These Dynatrac DynaLoc locking hubs (DT FO60-3B396-BB) fit 1978-1997 Ford F-250 and F-350 trucks with 35-spline axleshafts. Dynatrac says the DynaLoc gives you better locking hub function, more strength and a shorter profile than a conventional hub, which gives you more clearance and fewer hub hits on the trail.
Features
- Dynatrac says these are 3 times stronger than other Dana 60 locking hubs
- Gears are made in the USA from heat-treated chromoly steel
- Gear tooth design meant to keep the hub from disengaging under high torque load
- Low profile knob assembly and a short, tough steel bezel, so less hub sticks out to catch rocks and obstacles
- Defaults to the locked position
- Bolt-on installation
- Takes 1/8 of a turn to engage
Check before you order
These are for the 35-spline setup only. Count the splines on your outer axleshafts before ordering. A retailer note says these will not fit factory 30-spline shafts, so if your truck still has 30-spline shafts these hubs are not the right ones. This listing is for the 1978-1997 Ford F-250 and F-350, and the Dodge and GM hubs are a separate part.
California Proposition 65 warning: Cancer and Reproductive Harm. See www.P65Warnings.ca.gov.